Hello
I am going to make animation of texture which is put on path constrait and move around. What is important to me is that texture has to me all the time in the 1 position, up 90 degrees relative to path. Problem is that whan path's arrow goes near curve, my bone with texture attached to, start go down instead to keep stable 90 degrees, in other words, stay in the same position but only move around path. I was trying to manualy set 90 degrees on the start and at the end of path but still, it keeps this angle only during 1st and the last frame, even when I put more points with set 90 degrees it will move down and then back to the point where I set my angle.
When I was trying to copy saved angle on the time line and paste it later, angle didnt save and instead have 90 degrees after paste it had 118, 200 etc. There is no problem to set manually angles for 5-10 frames but when I am going to make 40-100 frames animation it may be annoying.
Do you have any ideas for this ?
Hope I wrote clearly my problem, if not, let me know and try to explain simplier 🙂
